Airworthiness Directives

PDF Copy (If Available):



Preamble Information

Regulatory Information
47-21-13 REPUBLIC: (Was Mandatory Note 3 of AD-769-2.) Applies to Model RC-3 Aircraft Serial Numbers 5 to 234, Inclusive.

Compliance required prior to July 1, 1947.

Inspect the rivets of the forward end of the elevator control push-pull tube in front of the instrument panel for size, looseness and replacement as necessary. If the installation has been made with four 5/32-inch diameter rivets, replace with six 3/16-inch rivets (3 on each side evenly spaded). If four 3/16-inch diameter rivets are already installed and looseness exists, replace the loose rivets and install two additional 3/16-inch rivets (one on each side evenly spaced).

(Republic Seabee Service Bulletin No. 6 dated January 16, 1947, covers this same subject.)


Footer Information

Federal Register Information





Comments